computingsite.blogg.se

1. #PERIMETER INVISIBLE FENCE COLLAR HOW TO#
2. #PERIMETER INVISIBLE FENCE COLLAR INSTALL#
3. #PERIMETER INVISIBLE FENCE COLLAR PORTABLE#

Now you don’t need to create a physical fence around the boundary area of the yard. In this case, you need to wear the small Wireless Electric collar on your dog’s neck. When your pup tries to leave the yard, they receive a beep, vibration, and gentle shock.

#PERIMETER INVISIBLE FENCE COLLAR PORTABLE#

That’s where you find the wire breaks.The Portable Electric Dog Fences Invisible Fence Collar Pet System protects your dog from escaping the boundary area you set up for pet safety. As you get closer to the wire, the static will increase. This frequency is ideal for hearing the low-frequency static generated by the lawnmower via the buried wire. Start the lawnmower and AM radio (tune to 530 kHz).

Turn off and disconnect the main fence line from the transmitter.Ĭonnect one end of the test wire to the lawnmower’s spark plug cable-the other end to the disconnected fence line. (A lawnmower, a few inches of test wire, AM portable radio) You can try the below DIY method by using 03 equipment you already have at home. Method 03: Diy Method (Spark Plug & Frequency Method) You can find it by using a wire break locator tool. That’s when you need a specialized tool to locate the wire breakage/s. It can be hard to find the breakage in a bigger yard. Remember, use this method only if you have a smaller yard. You must carefully pull out all of the underground wire in your yard to inspect for any breakage. Turn off your invisible fence system & carefully dig up the soil to find the underground dog fence wire. You should locate the underground wire a few feet away from the collar beep. Walk towards the invisible fence perimeter from the starting point. Hold the receiver collar close to the ground.

#PERIMETER INVISIBLE FENCE COLLAR HOW TO#

Method 01: For Smaller Yards How to Locate the Underground Wire Break: You’ll need to carefully dig up the invisible fence wires to locate the wire break. If all tests passed, there might be a break in the boundary wire. If the problem remains, call customer service for a new collar. You should replace the batteries if it doesn’t beep and the test light doesn’t flash.Hold the test light contacts from the contact posts to check whether the collar beeping but not shocking.It should beep when you get about a foot in length from the wire.Ĭheckout this guide if you want to know how to test an invisible fence battery. Hold the receiver collar next to the test wire. Receiver Collar Troubleshoot Test Invisible Fence Collar Battery If the lights TURN OFF when you disconnect one end, your transmitter is working perfectly.If the light DOES NOT TURN OFF, the fence transmitter is malfunctioning. Next, disconnect one end of the test wire from the transmitter.Move on to the next test if the indicator does light up.If not, the fence control panel is not working. Once the test wire loop is connected, the transmitter light should light up.You’ll need to unplug the current fence wires and connect a temporary 15-foot loop of fence wire to the transmitter to carry out some tests to see if the transmitter needs replacement. Transmitter Troubleshoots Preparation: Connect a 15-Foot Test Wire to the Transmitter Secondly, increase the static correction level.

#PERIMETER INVISIBLE FENCE COLLAR INSTALL#

First, install the most suitable contact probes and properly fit the collar. Your dog might not even notice the current static correction. Replace, if needed, with the invisible fence backup battery or purchase new collar batteries. Your dog may be escaping because the collar batteries are dead.